LOFTNESS 481EL, Руководство оператора

Страница: 17 / 42

Owner’s Manual (Hydraulic Standard Flow Snowblower)
N14813 2 - August, 2011 1
Set-up and Operating Instructions
Equipment Set-up:
The initial set-up of this machine will require you to
become familiar with all hazard warnings and safety
precautions listed in this manual. Review the
illustrated parts lists (section 4) to become familiar
with the component parts and how they are
assembled.
The snowblower may be shipped in a wooden
packing crate with the spout and rotator controls
packaged separately. The spout deflector controls
will be pre-assembled onto the spout. Unpack all
components. Assemble the spout and rotator
controls onto the snowblower and verify equipment
set-up as follows:
1.
Assemble the 1/2” step washers (Figure 1, item
#1), 1/2” x 3/8” shoulder bolts and lock nuts
onto the spout gear on one side only of the
spout, but do not tighten down.
Figure1
2. Apply grease onto the spout base ring (Figure 2)
Figure 2
3. Slide the spout onto the base ring (Figure 3)
checking to insure that the step washers catch
the base ring, install the remaining step washers,
shoulder bolts and lock nuts, then tighten.
Figure 3
4.
Rotate the spout by hand to check for binding,
re-adjust the bolts if binding occurs as the spout
should rotate freely.
5.
Attach the spout rotator control onto the
bracket as shown below (figure 4).

The electric spout control (figure 4) is pre-
assembled and will use (4) 3/8” bolts, flat
washers, lock washers and nuts to attach the
control onto the bracket as shown, do not
tighten the bolts, then align the spout rotator
gear and the drive sprocket. Tighten the
bolts, and check rotation of spout, adjust if
binding occurs.
Figure 4
Attach the wiring harness for the electric
spout control option (figure 5) as follows:
A. Mount the 2-way selector switch in a
convenient location near the operator.
B. Select an appropriate 12 volt power
source that will supply 10 amps
continuously.
C. Install a 20 amp inline fuse to the power
source.