71
This can be any of the touch-control heaters. When the timer value runs out, the heater
associated with the timer switches off.
The heater associated with the timer can be can be selected.
Selectable heater
The user can select the heater on which the timer function is to operate. The
selection of a new heater disables the previous selection in such a way that the timer only
operates on
one heater each time.
The heater must always be selected before the time is set; otherwise, the timer will switch off.
If we take longer than 10 seconds to select the heater, the timer will switch off.
If, after selecting the heater, the time is not defined (T=00) in 10 sec., the timer switches off.
It is possible for the user to time a heater at power 0 .
If the configuration permits Alarm-mode , instead select a heater , the user touches again the
timer in the heater selection periode, it goes to minute-minder mode and at the end of time will
not switch-off any heater.
In Alarm-mode, the dot of the timer display doesn’t light.
Indication of the heater on timer with “t” on the heater display.
The touch control indicates the heater on which the timer is operating. This indication consists
of a “t”
blinking with the power level in the display of the heater., 5sec every 15 sec. Also if the user
changes the value of the timer, the “t” blinks.
This option reminds the user at all times that the heater is on timer.
Indication of the heater on timer with Led (small symbol)
The touch control indicates the heater on which the timer is operating. This indication consists
of a LED (small symbol)
next to the double display of the heater on timer.
This option reminds the user at all times that the heater is on timer.
Increasing the value of the timer
If the sensor (+) or (-) associated with the timer is held down, the value increases/decreases
automatically.
This makes it possible to reach the desired timer setting more quickly. From the tenth
consecutive increase/decrease of the timer setting, the speed at which the value changes
increases.
Duration of the warning
When the time set on the timer has run out, a beep sounds for 1 minute, or indefinitely (this
option is also configurable), and the timer displays flash the indication <00>
o
1-minute alarm:
After 1 minute from when the timer alarm starts, the beep stops. The timer
displays
continue to flash with the indication <00>. The alarm can be cancelled by the user at any time,
even
during the first minute of the alarm, by pressing any sensor on the touch control.
o
Indefinite alarm:
The beep does not stop until the alarm is cancelled by the user. It can be
cancelled by pressing any of the sensors on the touch control.
Auto power-off
If the power level is not changed during a preset time, the corresponding heater turns off
automatically.
