Lode OEM, Руководство по обслуживанию

Страница: 58 / 68

Service manual OEM treadmill V2.03 58
6.4 Walking belt tension
In case the belt tension needs to be readjusted, e.g. after replacement of the belt you must
follow the procedure below:
1. Remove the caps (figure 3, A)
2. Make sure there is no tension on the belt, you should be able to lift the belt at
least 2 cm without feeling tension.
3. Place two markers on the belt exactly 1000 mm from each other (figure 1)
4. Now start tightening the belt till the distance between the two markers is 1003
mm (figure 2)
5. To prevent from unnecessary disturbance of the run belt alignment the number
of turns should be kept equal on both screws (figure 3,B)
6. To align the belt, follow the procedure in the next chapter.
Figure 1 Figure 2
Figure 3