16
For Your Safety
1
IMPORTANT DO NOT OPERATE UNIT BEFORE READING THIS SECTION
WARNING: Ultraviolet Light–Danger of severe eye or skin burns. Do not look at source or its
reflection without protective goggles. Do not defeat lamp shielding interlocks. Read operator's
manual before use or repair.
The Loctite
®
ZETA
®
7216 High Intensity Cure Chamber is a source of ultraviolet light used to
cure light sensitive products. The system incorporates ultraviolet shielding, an interlocked
chamber door, and a shutter to protect the user. It is safe when installed and used properly. The
following guidelines should be followed at all times to ensure protection from the ultraviolet light.
1. All personnel involved in the operation of the ZETA
®
7216 High Intensity Cure Chamber
should become familiar with the safety and operating procedures provided in the written material
provided with this equipment. Ultraviolet burns are not felt for several hours and short exposure
can cause severe burning of the skin. Never look directly at the output of the lamp or the output
of the lamp reflector. The ZETA
®
7216 is shielded and interlocked to prevent exposure to
ultraviolet radiation.
2. Do not defeat any of the system interlocks.
3. Do not attempt to open the chamber door during the cure cycle. A cycle stop button is
provided to terminate curing and close the protective shutter. If the door is opened, the unit turns
down power and closes the shutter, but the best procedure is to push the cycle stop and wait for
the shutter to close prior to opening the chamber door.
4. Prior to any attempt at servicing, turn the power off and remove power from all of the system
components.
5. When changing the lamp, allow 15 minutes for the lamp to cool prior to removing.
Ultraviolet safety is the responsibility of the user. When in doubt about ultraviolet safety, consult
a Loctite technical specialist at 1-800-LOCTITE (562-8483).
984135 Zeta 7215 & 7216 manl 8/3/00 3:24 PM Page 18
