7
6
Care, Cleaning, and Maintenance
6.1 Char
Removal
If the Hysol
®
Wheel Coater is over heated a brown or black flaky crust will form on exposed
surfaces of the glue pot. This is charred adhesive that can be removed using the following
procedure.
• Wear heat resistant leather gloves.
• Warm the machine to operating temperature.
• Pour out excess adhesive.
• Scrape off excess adhesive and char with a wood tongue depressor.
• Allow machine to cool.
• Use a paintbrush to apply a coating of solvent-based paint remover to remaining char.
• Allow paint remover solvent to soak on the char. It may be necessary to allow paint remover
to soak overnight.
• Remove softened char and reapply paint remover as required.
6.2 Clutch
The clutch is factory set and seldom needs adjustment. In the event that additional torque is
needed the following is the torque setting procedure:
1. Remove chain guard.
2. Remove set screw on clamping nut.
3. Use square socket on thread end of hub to secure shaft.
4. Tighten clamping nut against Belleville washer. Do Not completely flatten Belleville washer.
5. Replace set screws.
6. Replace chain guard.
CLAMPING NUT
BELLVILLE WASHER
SET SCREW
SHAFT
SPROCKET
FRICTION
MATERIAL
Figure 2
