1.1
Emphasized Sections
WARNING!
Refers to safety regulations and required safety measures that protect the operator or other
persons from injury or danger to life.
Caution!
Emphasizes what must be done or avoided so that the unit or other property is not damaged.
Notice:
Gives recommendations for better handling of the unit during operation or adjustment as well as
for service activities.
1.2
For Your Safety
• For safe and successful operation of this machine, read these instructions completely. If the
instructions are not observed, the manufacturer can assume no responsibility.
• Observe general safety regulations for the handling of chemicals such as Loctite adhesives
and sealants. Observe the manufacturer’s instructions as stated in the Material Safety Data
Sheet (MSDS).
• While under warranty, the machine may be repaired only by an authorized Loctite service
representative.
• Wear heat resistant leather gloves when operating or maintaining a hot machine.
• Always use extreme care when using the Hysol
®
Wheel Coater.
• Roll temperature and adhesive may reach 400°F. Avoid skin contact with the roll.
• If molten adhesive is accidentally deposited on skin, immerse immediately in cold water.
DO NOT ATTEMP TO REMOVE LARGE AMOUNTS OF GLUE FROM SKIN WITHOUT
FIRST SECURING PROPER MEDICAL ATTENTION.
• Check that the surface to be coated will not melt or be damaged by the temperature of the
adhesive and roll.
• Do not use the machine in damp or wet areas.
• Make sure the machine is properly positioned and secured to a sturdy, stable work surface to
avoid tipping and spilling hot melt adhesive onto the machine operator.
• Do not operate the machine with the pot cover in the raised position. Keep cover in place over
molten adhesive.
• Always us a properly grounded 120V outlet. Do not remove the grounding prong from the
machine electrical plug.
1
1
Please observe the following
☞
