Loctite CL15 UV, Руководство по эксплуатации

Страница: 14 / 22

5. Operating the Unit, (continued)
Lamp Hour Reset
The lamp hour meter is used to keep track of the time that the given bulb has been in
service. Once the bulb has been changed the lamp hour meter should be reset to accurately
track the service of the new bulb. Determine if you would like to reset your lamp hour
meter and make your selection using the
(+) or (-) button. Once this parameter is set press
ENTER to continue. NO is set as the default in case the user is cycling through the
functions quickly.
Save Parameter Changes
At this point all the parameters have been changed to the user
’
s preferences. These changes
have not been saved to memory, and if they are not, all parameters will revert back to the
previous values. At this point the user is prompted to save the changes. Determine if you
would like to save the changes to memory and make your selection using the
(+) or (-)
button. Once the selection has been made, press ENTER to continue.
Notice: At any time, while making changes to the parameters, if the user pauses for
longer than 7 seconds, the display will return to the “System Ready” screen and no
changes will be saved.
6. Inserting and Removing the Light Guides
Caution!
Be sure to remove the plastic end caps before attempting to use the light guide.
Caution!
If the free end of the light guide is secured at a fixed location, sharp bends should be
avoided since this causes a decrease in UV power.
Caution!
Never pull on the jacketing portion of the light guide. During installation or removal,
grasp the light guide on the strain relief nearest the input end of the light guide.
Notice: If the light guide does not go all the way into the receptacle, do not attempt
to force it. Adjust the set screw on the side of the receptacle until the light slides in
freely.
6.1 Installing single light guide
Insert the large end of single light guide into the light guide receptacle located on the left side
of the front panel. Push light guide firmly until it is fully engaged.
Installing dual light guide – Insert the dual wand light guide into the light receptacle and
rotate. See section 6.2 “Adjusting Wand for Maximum Output.”