Loctite 175, Руководство по эксплуатации, Страница: 5 / 14

4 Installation
Before using the tool for the first time check it carefully for signs of external damage.
If any shipping damage is found DO NOT USE THE TOOL - return it to your
supplier immediately.
Steps 1 –5 should be followed before connection to the main power supply :
1. Assemble the enclosed stand into the grooves at the base of the handle.
2. Check that the Plug-In Module is the appropriate one for the adhesive to be
used (refer to the Spares and Accessory lists at the end of this manual).
3. Pull handle back fully.
4. Drop adhesive cartridge into the breach of the tool and push fully forward.
5. Advance handle/plunger to rear of the adhesive cartridge by operating trigger.
6. Connect tool to main power supply.
7. Red “Power On”indicator light will illuminate.
8. Allow tool to warm up for 5 minutes. Do not attempt to operate the tool until
this time has elapsed.
9. Operate trigger to push the adhesive cartridge forward to the reloading point.
10. Pull handle back fully and load a second adhesive cartridge. Operate trigger to
advance handle/plunger.
With a new tool it will be necessary to operate the trigger several times before
adhesive can be extruded; air trapped in the heater housing needs to be evacuated.
ADHESIVE CARTRIDGES
PLUG-IN MODULE