101+ DELAYED EGRESS
MAGNETIC LOCKING SYSTEM
6
FORM 10111 Rev. C
04/11/2002
3. ATTACH MOUNTING PLATE AND
ALIGNING TEMPLATE TO HEADER
Slotted holes and counterbore should face downward.
Mount to the frame using (2) #10-24 x ½" pan head
machine screws, or (2) #10 x 3/4" pan head self-tapping
screws, and #10 flat washers. Tighten screws just tight
enough to allow shifting the plate during adjustment.
Install plastic aligning template onto mounting plate using
flat head machine screws. Note the direction of the door
face.
DOOR
STAR LOCKING
WASHER
TAPERED WASHER
ARMATURE
SEX NUT
DSM BLOCK
(
OPTIONAL
.
REQUIRED ON MODELS
WITH DSM
,
SEC
,
AND
/
OR BOCA
OPTIONS
)
2. MOUNT ARMATURE TO DOOR
Assemble using hardware provided in the order shown.
All hardware shown must be used except where noted.
Note that the tapered washer must be placed with the
pointed side facing away from the door and toward the
armature. It MUST be used for proper operation.
Use
hex key to tighten the armature mounting bolt. For solid
core and hollow metal doors, gently tap sex nut into posi-
tion with a rubber mallet before mounting armature
assembly.
Proper use of hardware will allow armature to
pivot slightly after securely tightening the mounting
screw. This is normal, and necessary to allow armature
to mate properly with magnet.
CAUTION:
Failure to secure armature to door may result in serious
injury to door user. For proper operation, safety and
security, sex nut / bolt assembly, washers and spacers
must be assembled in the order illustrated and securely
tightened 1/8 to 1/4 turn past hand tight.
FLAT WASHER
(
WOOD DOORS
ONLY
)
4. ALIGN PLATE TO ARMATURE USING PLASTIC ALIGNING TEMPLATE
Close door. Push template/mounting plate assembly toward door until it comes against the armature leaving no gap. Tighten pan head screws completely. Mark the posi-
tion of the mounting plate. Remove plastic alignment template from the mounting plate without moving the mounting plate. Remove plastic template
.
PUSH HERE TO
CLOSE GAP
101+DB
101+DB
