101+ DELAYED EGRESS
MAGNETIC LOCKING SYSTEM
18
FORM 10111 Rev. C
04/11/2002
MANUAL PROGRAMMING - TOUCHENTRY
When manually programming the 101+ model lock for TouchEntry Keys, a programmer (either the TEP1 or TEP2) must first be initialized. Only one programmer can be
initialized to a particular lock. A Master TEK must also be initialized at the same time as the programmer and will be used to enter the programming mode. See steps
below. After entering the Master TEK the green LED on the TouchEntry Key reader will flash. It will also flash each time that * is entered. Wait for the LED to stop flash-
ing before entering the next sequence. The TEP1 and TEP2 programmers are intended to simulate a keypad.
PROGRAMMER INITIALIZATION TEP1 AND TEP2
A. Set SW4 dipswitch #1 to ON.
B. Press and hold switch SW2 for two quick beeps of the audible..
C. Touch a TEK key up to the reader. (This TEK will be initialized as a MASTER TEK.)
D. Touch each TEK of the TEP1 to the reader in the following order(two beeps of the
audible will sound indicating acceptance of each key.)
(For TEP2 plug communication plugs into ports and push each button in order)
*
Wait for LEDs to stop flashing before touching next key or pushing next button.
* Waiting for longer than 7 seconds will terminate initialization.
E. After the last key/button is entered, the audible will beep three times and the LEDs will
flash indicating that programming has ended.
F. Return SW4 dipswitch #1 to its original position.
TO DELETE TEKs
Master TEK...5 *...Old PIN*...* (to end)
MORE TEKs CAN BE DELETED BY
RETURNING HERE.
TO DELETE TEKs (WITH ALARM/ATR NOTICE):
TEKs will be not be allowed to function but will remain in memory.
When the TEK is used, the lock will go into alarm, the alarm relay will close, the audible will sound and the LED will illuminate red. The door will not
unlock. It will stay in alarm until a valid user code, TouchEntry Key or reset input will silence the alarm. If the ATR option is present and the unit was pro-
grammed by computer, an access attempt will show in the audit trail.
Master TEK...55 *...Old PIN*...* (to complete)
MORE TEKs CAN BE DELETED
BY RETURNING HERE.
TO ADD NORMAL ACCESS TEKS -
Will unlock door for relock time delay period. Will also reset lock after an alarm condition.
Master TEK...3 *...New PIN(3-8 digits)*...New Access TEK...* (to complete)
UP TO 150 NEW TEKs CAN BE
ADDED BY RETURNING HERE.
