INSTALLING THE DOORS SENSOR
Step 9
2-3/4"
70mm
2-3/8"
60mm
Make sure you have prepared the door sensors for
installation according to Step 7
1
3
2
Peel off the paper layer of the
adhesives from the back of the
wired sensor
AA
.
Position the wired sensor
AA
to
the edge of the door, avoiding
the door strike plate. Attach and
secure with the adhesives.
Close the door. Before you peel off
the paper layer of the adhesives from
the sensor magnet
AB
, align the arrow
with the wired sensor
AA
. Install
AB
on to door frame.
NOTE:
The arrows must be aligned or as closed as possible (less than
3/4"). If needed, adjust the position of the sensor magnet using
provided foam pads to ensure the Lockly logo blinks red when
door opens or closes.
26
2-
3
4
"(70mm)
2-
3
8
"(60mm)
