User’s Information Manual
8
Lighting Instructions for Spark Ignition
Pilot Models
FOR YOUR SAFETY READ BEFORE
OPERATING
WARNING
If you do not follow these instructions
exactly, a fire or explosion may result
causing property damage, personal injury
or loss of life.
A. This appliance is equipped with an ignition device
which automatically lights the pilot. Do not try to
light the pilot by hand.
B.
BEFORE OPERATING
, smell around the appliance
area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will settle to
the floor.
WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance.
Do not touch any electric switch; do not use any
phone in your building.
Immediately call your gas supplier from a near by
phone. Follow the gas supplier’s instructions.
If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to turn the gas control knob.
Never use tools. If the knob will not turn by
hand, don’t try to repair it, call a qualified ser vice
technician. Force or attempted repair may result in a
fire or explosion.
D. Do not use this appliance if any part has been
under water. Immediately call a qualified service
technician to inspect the appliance. The pos si ble
damage to a flooded appliance can be extensive and
present numerous safety hazards. Any appliance
that has been under water must be replaced.
Operating Instructions
1.
STOP! Read the safety information first.
2.
Remove the control panel door.
3. Set the thermostat to the lowest setting (OFF).
4.
Turn off all electrical power to the appliance.
5. This appliance is equipped with an ignition device
which automatically lights the pilot. DO NOT try to
light the pilot by hand.
6a. 45,000 - 135,000 Btu/hr models, rotate the gas control
knob on the gas valve clockwise to the “OFF” position.
6b. 180,000 - 260,000 Btu/hr models, rotate the gas control
knob on the gas valve clockwise to the line on the collar
around the knob. Depress the knob and continue
rotation to the “OFF” position.
7. Wait five (5) minutes to clear out any gas, then smell for
gas, including near the floor. If you smell gas, STOP!
Follow the steps in the
“What To Do If You Smell Gas”
section in the safety information. If you do not smell gas
go on to the next step.
8a. 45,000 - 135,000 Btu/hr models, rotate the gas control
knob on the gas valve counterclockwise to the “ON”
position.
8b. 180,000 - 260,000 Btu/hr models, rotate the gas control
knob on the gas valve counterclockwise to the line on
the collar around the knob. Al low the knob to “pop”
up, and continue rotation to the “ON” position.
9.
Turn on all electric power to the appliance.
10. Set the thermostat to the desired setting.
11. Re-install the control panel door.
12. If the appliance will not operate, follow the instructions
“To Turn Off Gas To Appliance”
and call your service
technician or gas supplier.
2
Operating instructions
Содержание 000 BTU/HR
Страница 10: ...10 NOTES ...
Страница 11: ...NOTES 11 ...
