9
LCN-GT10D
Installation guide
Local Control Network
®
Inscription
You will find the inscription software LCN-GT on the
enclosed CD for designing your inlays. The caption inlay
must be cut to
61 mm * 90 mm
. Standard 80g reprogra-
phic paper is suitable and unproblematic for processing.
Semitransparent paper/inlayer is even better for the
optimum luminance of the LED´s.
Inserting the inlay into the key-sensor
Pull the plastic slider at the rear of the key-sensor to the
side. Guide the inlay through the slit on the bottom edge
of the LCN-GT10D as far as it will go.
Tip:
When each corner of the inlay is trimmed around
2mm, it is easier to guide through the slit. When changing
the inlay/paper, the GT10D should be removed from the
wall.
