LOBSTER EH-19PCU, Руководство пользователя и инструкции по эксплуатации

Страница: 8 / 13

Maintenance
1. Changing the blades. If a blade is dull or damaged, immediately replace
with a new blade. Cutting with dull or loose blades WILL damage the tool.
Unplug the tool before starting maintenance of any kind.
2. Check the length of the carbon brushes every six months. Unplug the tool
and loosen the brush caps using a screw driver. Replace if worn to less
than ¼” long. Sparks will be generated and the motor will be damaged if
operated with bad carbon brushes.
3. Check the oil every six months. Only use hydraulic oil with a VG 46
weight rating. If not available in your area, order from Fascut Industries.
a. Make certain moving cutting blade is fully retracted.
b. Unplug the tool and position so the oil cap faces upward.
c. Remove the oil cap using an M8 Hex Key Wrench.
d. Fill the oil to the point of over flow.
e. Replace oil cap and tighten.
Caution – Care should be taken to prevent hydraulic oil from entering the motor
housing.