Phone: 800.526.4041
Fax: 818.764.6061
Replacing and Installing a Arc Gear on the Platform.
Repair Instructions
Elite Models that Apply: EL04, EL05, EL05-LE
Step
Description
Tools
Picture
1
Removing The Case
Step 1.)
Unscrew the (6) Phillips-head screws along the
bottom of the red case where it attaches to the chassis
of the machine. (2-front, 2-rear, one on each side)
Step 2.)
Lift the red case off the chassis and set it aside.
Phillips Screw
Driver
Case Screws (Front & Rear)
Case Screws (Side)
Case Removed
2
Removing The Platform
Step 1.)
Using a 9/16” crescent wrench, and a 9/16”
wrench, hold onto the bolt which is outside of the
machine underneath the platform, while unscrewing the
nut attached to the other end of the bolt, inside the
machine (below the bottom server wheel).
Step 2.)
With the Platform detached, position it so that
the 4 rubber feet are touching the ground, and the white
plastic spacer is pointing up.
Phillips Screw
Driver
9/16” Crescent
Wrench
9/16” Wrench
Platform with Nut removed.
Platform being removed from
Chassis.
