Load Cell Systems WDESK-L, Инструкция по установке и эксплуатации

Страница: 49 / 68

- 44 -
SLOW

(from 0 to maximum weight; default: 0): adjustable parameter for each product. By slow value
we mean the value that, when subtracted from the weight set, minus the fall value, starts the
batching slow phase (closing the relative contact). If the value set is higher than the weight to be
batched, batching will be all in slow phase. Setting 0 disables this function.
Esempio: If PRODUCT = 100, SLOW = 15 and FALL = 10, the slow phase starts when the weight
reaches 75.
TAPPING FUNCTION
In the event that the batching instrument is not equipped with the speed “slow” it is possible to use
this function to slow down the product batching in the final phase (through opening and closing
cycles of the PRODUCT contact) and to increase the accuracy. Set in
 parameter the product
amount you want to batch with the tapping function enabled.
SLOW ON
 (from 0 to 9.9; default: 0): time in which the PRODUCT relay remains closed during the
SLOW phase. By setting 0, the function is disabled.
SLOW OFF
 (from 0 to 9.9; default: 0): time in which the PRODUCT relay remains open during the
SLOW phase. By setting 0, the function is disabled.
AUTOTARE

(from 0 to 1; default: 1): autotare enabling (automatic tare at the batching start).
-
 : autotare disabled
-

: autotare enabled
This operation is possible only if the gross weight is lower than the minimum weight (

),
otherwise the  alarm message is displayed.
CONSUMPTION FOR EACH PRODUCT

(default

): enabling consumption memory (total batched quantity) for each product.
-

: consumption enabled;
-

: consumption disabled.