- 25 -
TARE WEIGHT ZERO SETTING
This menu may also be accessed directly from the weight display, holding down the
key for 3 seconds.
Perform this procedure after having set the THEORETICAL CALIBRATION data.
Use this function to set to zero the weight of the empty system after commissioning and then later
on to compensate zero variations due to the presence of product residues.
Procedure:
-
Confirm the message
by pressing ENTER.
-
The weight value to be set to zero is displayed. In this phase all of the LEDs are flashing.
-
Confirming once again, the weight is set to zero (the value is stored to the permanent memory).
-
Press
to display the value of the total weight reset by the instrument, given by the sum of all
of the previous zero settings.
ZERO VALUE MANUAL ENTRY
WARNING: perform this procedure only if it’s not possible to reset the weighed structure tare, for
example because it contains product that can not be unloaded.
Set in this parameter the estimated zero value (from -999999 to 999999; default: 0).
REAL CALIBRATION (WITH SAMPLE WEIGHTS)
After having performed the THEORETICAL CALIBRATION and TARE WEIGHT ZERO SETTING,
this function allows correct calibration to be done using sample weights of known value and, if
necessary, any deviations of the indicated value from the correct value to be corrected.
Load onto the weighing system a sample weight, which must be at least 50% of the maximum
quantity to be weighed.
By confirming the message
the flashing value of the weight currently on the system is
displayed. In this phase all of the LEDs are off. Adjust the value on display by using the arrow keys if
necessary. After confirming, the new set weight will appear with all the LEDs flashing.
After an additional confirmation, the message
will be restored and by repeatedly pressing
the key ESC the weight will once again be displayed.
0
+
+
+
Содержание WDESK-L
Страница 27: ...22 BATCHING CONSTANTS it appears only if in constants TOTAL YES...
Страница 66: ......
Страница 67: ......
