LNS Sprint 545 S2, Инструкция по эксплуатации

Страница: 81 / 114

CHAPTER 8: HANDLING 8-9
SPRINT 545/565S25
Designation Article No Description
A Pusher assembly
B Loading finger
C Split guiding elements (or shells) for the pusher carrier
D Pusher carrier guiding element retaining handles
E Guiding module elements
1. Once the pusher in changeover position, open the main access cover.
2. Remove
the pusher.
3. Guiding elements change :
Once the pusher assembly is in the rear position, pull all of the front and rear guiding elements
(E)
upwards to remove them and replace with new elements. Remove the two pusher supports (C) ; to do so,
unscrew the handles (D) and fit new ones, then screw in the handles.
4. Replace the loading finger
(B) , if necessary, according to the new diameter of the elements.
5. Install the new pusher and place it in the guiding elements.
6. Validate the pusher modification.
4
Enter the manual menu.
5
Follow the instructions on the remote control screen.
Change the guiding channels diameter if necessary.
Once the guiding channel diameter has been changed, press the Start button.
The pusher is engaged in its home position.
Once the bar feeder has completed the pusher changeover cycle, the bar feeder is
ready to work. At this point, it is necessary to check and change parameters such
as the bar diameter, feeding length, etc.
See this chapter, section SETTINGS for further information.
3.1.1. Changing the front rest
When the guiding elements are worn, have a standard replacement of the front rest performed. To do so,
contact LNS SA.