LNS Express 220 S2, Инструкция по эксплуатации

Страница: 70 / 119

CHAPTER 8: HANDLING 67
EXPRESS 220 S2/320 S2
3. SET-UP
Please read the safety instructions provided at the beginning of this manual before
handling the following devices.
All handling, adaptations and settings required by the bar feeder to carry out a specific job are part of the
set-up.
A few simple operations are necessary to prepare the device to handle another range of diameters.
The set-up must be modified when following parameters change:
1. Bar stock diameter
2. Bar stock shape
3. Part length
3.1. BARFEED MECHANICAL SETUP
3.1.1. Adjusting the bars magazine
The upper limiters should be set to each support.
The inclination of the plane is always the same, regardless of the diameter, the profile or bars of material
to be charged.
Procedure:
·
Loosen the lock adjustable handles (
D
) and remove the upper limiter (
A
).
·
Place a few bars of the desired diameter on the inclined plane (
B
), resting on the stops (
C
).
·
Lower the upper limiters (
A
) so that the clearance between the limiter and the bars is about 1 mm.
·
Tighten the locking adjustable handles (
D
).
A
B C
D