LK Floor Heating | Assembly Instructions | LK Room Temperature Control ICS-RF8
14
EN.33.C.891008
NOTE:
The system clock must be set accurately for this feature to
work properly.
Weekly program - temperatures
The units are supplied with the following default temperature values:
Comfort = 20 degrees
Economy = 18 degrees
Change temperatures as follows:
1.
Press
Mode
until
flashes, confirm using
Mode
.
2. Select
Eco
for night reduction temperature, confirm using
Mode
.
3. The temperature flashes, change the temperature using the left/right arrow, confirm using
Mode
.
Repeat the above but select
Comfort
for "day temperature".
NOTE:
The above programming applies only to that specific room
thermostat. Repeat the above steps for all other thermostats.
Weekly program – week days/weekends
The unit can be programmed for every day of the week (1-7) or programmed for weekdays & weekends (1-5
& 6-7).
Select the program as follows:
1.
Press
Mode
until
flashes, confirm using
Mode
.
2. Select
WKMD
(Week Mode) using the left/right arrows, confirm using
Mode
.
3. Select either 1-7 or 1-5/6-7 using the left/right arrows, confirm using
Mode.
NOTE: The setting applies to all thermostats connected to the same receiver unit.
Weekly program - start/stop times
The unit can be programmed for two event times per day, i.e. at which time the unit will switch between day
(Comfort)
and night
(Economy)
.
Follow these steps to set the time:
1.
Press
Mode
until
flashes, confirm using
Mode.
2. Press the left/right arrow until the choices below are displayed, confirm in
Mode
.
WK01 = start time comfort, days1-7 days, choose the time with the left/right arrow, confirm with
Mode
WK02 = stop time comfort/start time eco days 1-7, select the time with the left/right arrow, confirm with
Mode
.
WK03 = stop time eco/start time comfort days 6-7, select the time with the left/right arrow, confirm with
Mode
.