General information
2 Installation
2.1 Safety notes for installation
Do not install the radiant panel behind curtains, furniture or furnishings; do not install the
appliance at ground level or at an excessive height.
The radiant panel shall in no case be installed: in niches, less than 10 cm from the corners of
the room, under a power outlet or on a shelf.
The heater must only be installed on 230V rated voltage systems.
An omni-polar disconnecting device must be installed upstream of a power line with a contact opening of at
least 3mm.
The power supply circuit of the appliance must be protected with a
high-sensitivity differential protection
device.
2.2 Special notes for bathroom installation
The installation must conform to the rules and laws of the country in
which it is installed.
The heater is Class II and complies with electrical protection norm IPX4;
in the bathroom, it can be installed in zones 2 and 3 (see figure) provided
that the control device remains out of reach for people who are using the
shower or bathtub.
In the bathroom, the device may be installed in zone 3 (Fig. 1), defined
according to standard CEI 64-8/7, Art. 701.32, provided the controller
remains out of reach for persons using the shower or bathtub.
2.3 Installation
The thermostat is supplied with appropriate supporting hooks. Wall plugs supplied in the
package are suitable for brick or concrete walls. You can install the radiant panel also on
other wall types by replacing the plugs provided with other deemed most appropriate, and
checking with your installer whether the installation wall can bear the appliance’s weight.
The package provides three identical hooks and two of them are designed for weight bearing; adjustment
screws allow correction by adjusting small differences in the horizontal alignment of the panel. The third
hook, placed at the base, is mandatory and should not be tightened to high torque, as its rotation locks the
panel in a vertical position after installation.
Proceed with the installation of the panel by locating the position of the holes as per drawing, and use the ta-
ble for distances.
Proceed with the installation of the hooks, use a drill adapted to the tile and surface type to
be drilled; for the standard tile supplied, use a 9 mm diameter x 45mm deep tip.
Hook the panel to the upper brackets; rotate 90 ° the lower hook so this attaches to the wall
surface and to prevent the panel from being raised.
6
Classificazione delle zone bagno
( CEI 64-8/7 )
