8
0800 422 274
NZ
Instructions
Using the Heater
Location
• Place the heater in an upright position on a firm, level, dry and heat-
resistant surface, taking into considering all relevant safety information on
the previous pages.
• Ensure that there is sufficient distance from the wall, fixtures and other ap-
pliances and at least 1m at the front of the heater to exclude the risk of fire.
Connection
• Insert the power plug of the heater into an appropriate power point and
switch on power to the outlet.
• Always use a separate socket that has no other high wattage appliances
connected at the same time – do not plug it into a power board or socket
adaptor; do not use an extension cord.
Switching On/Off and Power Level Selection
• To switch on the heater, turn the Heat Control Knob clockwise.
• Turn the knob to setting [ I ] to select 500W heat output.
• Turn the knob to setting [ II ] to select 1000W heat output.
• Turn the knob anticlockwise back to [ O ] to switch off the heater.
• If the heater is not going to be used for an extended period of time, please
unplug it from the power source.
Oscillation
The heater has an oscillation (swing) function which helps distribute the warm
air over a larger area. Always switch off the oscillation function before you
switch off the heater.
• Press the OSCILLATION switch on top of the heater to start oscillation.
• While the appliance is oscillating, press the OSCILLATION switch again to
stop oscillation when the appliance is in the desired position.
When turning your heater on for the first time it is normal for the
heater to emit a ‘new heater’ smell, which will quickly pass.
This is no cause for concern. Ensure good ventilation.
