11
GB/CY
or corner mounting) in place by inserting
the screws (25mm)
19
through the guide
holes
17
/
18
and firmly tightening them.
Check that the wall bracket is fixed firmly in
place�
Unscrew the gland nut
11
from the outdoor
spotlight�
Remove the screws
14
from the cover plate
12
and pull it away far enough to be able
to access the terminal strip
6
attached to
the cover plate�
Feed the power supply cable first through
the gland nut
11
, then through the cable
grommet
15
, and finally through the cover
plate
12
before starting installation�
Connect the power supply cable to the
terminal strip
6
� Make sure that the
individual cable cores are correctly
connected� Take care to ensure that the
earth conductor
9
is made longer than
the other conductors so that if the cable is
torn away from the outdoor spotlight, the
earth conductor comes away last� Connect
the neutral conductor
10
to the terminal
marked N and the live conductor
8
to the
terminal marked L so as to avoid incorrect
installation and consequent damage to the
product or personal injury (see Fig� C)�
Secure the connecting lead (inc� outer
sleeve) with the strain-relief clamp
7
(see
Fig� C)�
Feed the terminal strip
6
back into the
casing and screw the cover plate
12
back
onto the outdoor spotlight�
Position the cable grommet
15
between the
cover plate and nut so as to obtain the best
possible seal and fix it in place by
hand-tightening the gland nut
11
�
Slot the outdoor spotlight onto the wall
bracket
16
from above and screw it to the
bracket using the two screws (10mm)
21
(see Fig� G)�
Note:
The screw heads of the cover plate
must be countersunk so that the outdoor
spotlight can be fitted onto the wall bracket.
Switch the circuit-breaker for the circuit back
on or replace the fuse�
Setting the beam width
Tilt the outdoor spotlight to the desired
position (see Fig� H)�
z
Operation
The outdoor spotlight is operated by means
of the three control knobs on the bottom end
of the light (see Fig� B)�
Set the switch
13
to position “I” to activate
Always On mode� Set the switch
13
to
position “0” to activate Automatic mode
(motion sensor)� In this mode the following
settings are possible�
Setting the detection range
Turning the SENS control
5
clockwise
increases the detection range so that the
motion sensor responds to movement as far
away as approx. 12m (see Fig. B).
Turning the SENS control
5
anticlockwise
decreases the detection range so that the
motion sensor only responds to movement
as close as approx. 0.5m (see Fig. B).
Setting the burn time
Turning the TIME control
4
clockwise
increases the illumination time (max.
1 minute) (see Fig� B)�
Turning the TIME control
4
anticlockwise
decreases the illumination time (min�
10 seconds) (see Fig� B)�
Setting the sensitivity of the twilight
sensor
Turning the LUX control
3
clockwise
increases the sensitivity so that the motion
sensor will respond even in brighter
ambient light conditions (e�g� daylight) (see
Fig� B)�
