LIVARNO LUX 55081, Инструкция по сборке, эксплуатации и безопасности

Страница: 19 / 70

19 GB/IE
- Pencil / marking tool
- Voltage tester
- Screwdriver
- Power drill
- Drill bit
- Side cutters
- Ladder
Prior to installation
Familiarise yourself with all the instructions and
diagrams in this manual, as well as with the ceil-
ing fan with LED light itself, before you install it.
Before installation, ensure that the circuit to which
the ceiling fan with LED light will be connected is
not energised. To do so, remove the fuse or switch
off the circuit breaker in the fuse box (0 setting).
Before installation, make sure that the installation
site is suitable to bear the weight of the ceiling
fan with LED light.
Use a voltage tester to verify cables are not live.
Installation
Note: You will need a power drill for the installation
work.
Note: Please also follow the instructions for your
power drill.
Important: Before starting to drill, make sure that
there are no electrical cables in the place where you
wish to drill.
Installing the ceiling fan
with LED light
Note: Remove all packaging materials from the
product.
Remove the fuse or switch off the circuit breaker
(0 setting) in the fuse box prior to installation.
Unscrew the right-hand fixing screw
15
, which is
located at the side of the mounting bracket
12a
.
Remove the left-hand fixing screw
15
including
the washer and the tooth spring lock washer.
Mark the drill holes using the holes provided
for screws
8
in the mounting bracket
12a
.
Now drill the fixing holes. Be sure not to damage
the supply line, water pipes or electric cables.
Important! The chosen installation location
must be able to hold the total weight of the
ceiling fan.
Pass the connection cable (external) through
the hole provided for this in the centre of the
mounting bracket
12a
. Fasten the mounting
bracket
12a
using the included washers, spring
lock washers and screws
8
(see fig. A).
Using the holes provided for this, hang the
cover
1
on the hooks
12b
on the mounting
bracket
12a
(see fig. B).
Connect the connection cable (external) with the
lustre terminal
16
in the mounting bracket
12a
.
Please also be sure the colours of the connected
lines match (black or brown live wire = L symbol,
blue neutral wire = N symbol, protected ground
wire = green-yellow (see fig. B)).
Insert the mounting bracket
12a
connection
cable
17
into the connection cable port
18
of
the ceiling light (see fig. C).
Now place the cover
1
on the mounting bracket
12a
by guiding the screws
15
into the grooves
on the cover and then turning the cover
1
anti-
clockwise (see fig. D).
Now screw the ceiling fan with LED light and
the mounting bracket
12a
together, using the
four fixing screws
15
.
Ensure that it is positioned correctly (see fig. E).
Fasten the fan blades
14
to the fan blade hold-
ers
13
using the nuts
11
, spring lock washers,
washers and screws
10
(see fig. F).
Fasten the fan blade holders
13
to the rotor
housing
2
. To do this, use washers and the
screws
2a
pre-installed on the rotor housing
2
.
Ensure that printed side of the fan blades
14
is
facing down (see fig. G).
Insert the light bulb
19
as shown in figure H.
Attach the lampshade
7
. Use the pre-installed
thumb screws
20
for this (see fig. I).
CAUTION! Do not use pliers to fasten the
thumb screws
20
. This could cause the glass
of the lampshade
7
to crack. This could lead
to injuries caused by splinters of glass.