LIVARNO LUX 55081, Инструкция по сборке, эксплуатации и безопасности

Страница: 18 / 70

18 GB/IE
Avoid the risk of fatal injury
from electric shock
Have electrical installation performed by a trained
electrician or a person trained for electrical in-
stallations, in compliance with the applicable
standards.
Never use your ceiling fan with LED light if you
detect any damage.
Remove the fuse or switch off the circuit breaker
(0 setting) in the fuse box prior to installation.
Never allow the ceiling fan or the LED light to
come into contact with water or other liquids.
Never open any of the electrical equipment or
insert any objects into this equipment. Such in-
terferences pose a risk of fatal injury from elec-
tric shock.
Prior to installation, verify the available mains
voltage corresponds with the required operating
voltage of the product (see “Technical data“).
Be sure not to damage any wires during
installation.
Do not install the light on damp or conductive
surfaces.
This ceiling fan with LED light is not
suitable for dimmer or electronic
switches.
Prevent fire and
injury hazards
CAUTION! RISK OF BURNS DUE
TO HOT SURFACES!
Ensure the
ceiling fan with LED light has been
switched off and has cooled down before
touching it, in order to avoid burns. Light bulbs
become very hot.
Do not look directly into the light source. Do not
look at the light source with an optical instrument
(e.g. magnifying glass).
Replace defective bulbs with new ones immedi-
ately. Before changing light bulbs, ensure that
the circuit to which the ceiling lamp with LED
light is connected is not live. To do so, remove
the fuse or switch off the circuit breaker in the
fuse box (0 setting).
Allow the light to cool for at least 15 minutes
before replacing a defective bulb.
Do not under any circumstances use the product
to store or hang up other objects.
Never use the connection cable to carry the
weight of the product.
If you notice unusual oscil-
lations, stop using the ceiling fan immediately
and consult qualified personnel.
Should doubts arise during assembly / use of
the product, consult a qualified electrician.
For your safety
Install the ceiling fan with LED light in a location
where it is protected from moisture and dirt.
A ceiling height of at least 2.5 m is required for
safe operation. The fan blades must be at least
0.6 m away from the nearest wall. The ceiling
to which the product is mounted can slope by
a maximum of 30 °.
If the ceiling fan is mounted in a room in which
the fan blades are over 2.3 m above the floor,
make absolutely sure that there is a gap of
500 mm between the fan blades and the walls
or furniture.
Always be alert! Always pay attention to what
you are doing and always use common sense.
Under no circumstances should you install the
ceiling fan with LED light if you are having diffi-
culty concentrating or do not feel well.
Do not operate the product if the ambient air
temperature is over 40 °C.
Preparation
Tools and materials required
The specified tools and materials are not included.
The information and values specified are non-bind-
ing and are only provided as a reference. The nature
of the material is determined by the specific local
conditions.