14 GB/IE
Safety / Preparation / Installation
Risk of burns and injury!
Do not install the light, if it has a defective lamp
glass. In this case contact the service centre for
a replacement.
Only install the light on normally inflammable
or non-inflammable surfaces. Excessive heat can
result in a fire.
Never open any of the electrical equipment or
insert objects into these. This will pose the risk
of fatal injury from electric shock.
To prevent burns, ensure that the light is switched
off and has cooled down before touching it.
Lamps become very hot.
Do not look directly into the light source (light
bulb, LED etc.).
Only use the individual parts supplied, other-
wise all warranty claims will become invalid.
Do not use optical instruments to look at the
light source (e.g. magnifier).
Broken protective glass must be
replaced promptly. Please contact
the service centre or an electrician.
Safe working
The outdoor light is splash-proof.
Always be attentive! Always pay attention to
what you are doing and use common sense.
Never install the light if you are having diffi-
culty concentrating or do not feel well.
Preparation
Required tools and material
The tools and materials specified are not included.
This information and these values are non-binding
and are only provided as a reference. The nature
of the material is determined by the individual local
conditions.
– Pencil / marking tool
– Voltage tester
– Cross-tip screwdriver
– Electric drill
– Edge cutter
– Drill (ø 6 mm)
– Slotted head screwdriver
Prior to installation
Important:
Ensure that a qualified electrician, or
a person trained to carry out electrical installations,
performs the electrical installation.
Be sure the installation height of the light does not
present a risk of injuries.
Familiarise yourself with all the instructions and
diagrams in this manual, as well as with the light
itself, before you install it.
Before installation ensure that the circuit, to which
the light will be connected, is not energised. To
do so, remove the fuse or switch off the circuit
breaker in the fuse box (Position 0).
Use the voltage tester to verify the de-ener-
gised status.
Installation
Remove both screws
1
on the housing
2
(see Fig. A).
Remove the light base
5
from the housing.
Unscrew the light bulbs
4
from the socket
3
by turning them counter-clockwise.
Use the holes of the light base
5
intended for
the screws
14
to mark the drill holes.
Now drill the fixing holes. Be sure not to damage
the supply line.
Insert the wall plugs
13
into the drill holes.
Open the connection box
6
by removing the
rubber cover
7
and cover
8
. Remove the four
screws
9
from the connection box
6
to do
so. Now remove the rubber membrane
10
(see Fig. B).
If necessary, puncture the membrane
10
with a
sharp object.
Slide the membrane
10
onto the main insulation
of the mains cable (external)
11
.
Installation / Cleaning / Disposal / Warranty and service
