LIVARNO LUX 295693, Инструкция по сборке, эксплуатации и безопасности

Страница: 17 / 61

17 GB/IE
Replacing the
rechargeable battery
The batteries should be replaced every 12 months
to ensure optimum performance.
10392A/B:
Remove the lampshade
1
from the lamp
body
3
.
Pull the solar cell housing
2
out of the
lampshade
1
.
Switch off the light using the ON/OFF switch
7
by setting the switch to the „OFF“ position.
Remove the fastening screws
8
using a small
cross-tip screwdriver. Then open the battery
cover on the solar cell housing
2
using a
flat-head screwdriver.
Replace the old battery
10
with a new re-
chargeable battery, taking care not to damage
the cables. Please note the polarity when in-
serting the battery. This is shown inside the bat-
tery compartment
9
. Use only rechargeable
batteries of the recommended type (see
„Technical data“).
Close the battery cover and tighten the retain-
ing screws
8
using a small cross-tip screw-
driver. Set the ON/OFF switch
7
to the
„ON“ position.
Reattach the solar cell housing
2
to the lamp
shade
1
. Then assemble the remaining parts
of the lamp.
10392C/D:
Remove the lampshade
1
from the lamp
body
3
.
Turn the solar cell housing
2
out of the
lampshade
1
counter-clockwise.
Switch off the light using the ON/OFF switch
7
by setting the switch to the „OFF“ position.
Remove the fixing screws
8
using a small
cross-tip screwdriver.
Replace the old battery
10
with a new re-
chargeable battery, taking care not to damage
the cables. Please note the polarity when in-
serting the battery. This is shown inside the bat-
tery compartment
9
. Use only rechargeable
batteries of the recommended type (see
„Technical data“).
Tighten the retaining screws
8
with a small
cross-tip screwdriver. Set the ON/OFF
switch
7
to the „ON“ position.
Reattach the solar cell housing
2
to the lamp
shade
1
. Then assemble the remaining parts
of the lamp.
Charging
Please note, the solar garden light must be
switched on when the battery is charging. The
charging time via the solar cell varies by the inten-
sity of the sunlight and the incidence angle of light
onto the solar cell. Place the solar cell as perpen-
dicular as possible to incidence angle of light. This
will ensure the brightest light.
Maintenance and Cleaning
The LEDs cannot be replaced. The solar lamp is
maintenance-free, except for any necessary
change of battery.
Routinely clean the solar light with a dry, lint-
free cloth. Use a slightly moist cloth if very dirty.
Troubleshooting
Note: The device contains sensitive electronic
components. Radio transmitting equipment in the
immediate vicinity may therefore cause interfer-
ence. If you notice the device is malfunctioning,
remove any sources of interference from the area
around the device.
Note: Electrostatic discharge can cause malfunc-
tions. In the event of such malfunctions, briefly
remove and reinsert the rechargeable batteries.