LIVARNO LUX 290224, Инструкции по эксплуатации и безопасности

Страница: 14 / 49

14 GB/IE
Initial Use / Maintenance and Cleaning / Disposal / Warranty and Service
Avoid the risk of fatal injury
from electric shock
Always check the mains supply and the USB
connector for damage before connecting the
lamp to the mains. Never use the light if it
shows any signs of damage.
In the event of damage, repairs or other prob-
lems with the light, please contact the service
centre or an electrician.
Ensure that the light does not come into contact
with water or other liquids under any circum-
stances.
Never open or insert anything into electrical
fittings or equipment (e.g. switches, fitting socket).
This will pose a risk of fatal injury from electric
shock.
Only touch the insulated area of the mains
plug when connecting to or disconnecting from
the mains!
To prevent hazards, a damaged flexible outer
lead of this light may only be exchanged by
the manufacturer, his service representative or
by an equally qualified specialist.
Before every use, verify the available mains
voltage matches the required operating voltage
of the light (see “Technical Data“).
Always unplug the mains plug, respectively,
from the mains prior to assembly, disassembly,
cleaning, or when the light will not be used for
extended periods.
Safe working
Position the lamp so it is protected from moisture
and dirt.
Always be attentive! Always pay attention to
what you are doing and use common sense.
Do not cover the lamp with objects. Excessive
heat can result in fire.
Do not look into the illuminant from a close
distance during operation.
Do not use optical instruments to look at the
illuminant.
In order to disconnect the light completely from
the power supply, the mains plug must be remo-
ved from the socket.
The illuminant in this light is not replaceable; if
the illuminant reaches the end of its life, replace
the entire light.
Initial Use
Mounting the light
14126702L:
Connect the mains plug
7
with the mains
cable
6
.
Plug the mains plug
7
into a properly installed
socket.
Your light is now ready to use.
14126602L / 14126502L:
Check that all spacers
8
are equipped with
rubber sleeves
9
.
If necessary, place the rubber sleeves
9
over
the spacers
8
.
Bring the lamp glass
1
into the correct position.
Be sure it is correctly positioned.
Note: the lamp glass
1
is only placed on.
Ensure that the lamp is always firmly positioned.
Connect the mains plug
7
with the mains
cable
6
.
Plug the mains plug
7
into a properly installed
socket.
Your light is now ready to use.
Switching the light on / off
Press the ON / OFF switch
3
to turn the lamp
base
5
to turn the lamp on and off.
USB connector
Your lamp has a USB connector
4
in the
case. With this USB connector
4
you can
Safety / Initial Use