LIVARNO LUX 282514, Инструкция по сборке, эксплуатации и безопасности

Страница: 26 / 102

26 GB/IE
Mounting the solar cell
The solar cell
5
requires direct sunlight when possible. Ideally, the solar
cell surface will be directed to the south. The enclosed bracket
9
will en-
sure the solar cell is mounted horizontally.
Mount the bracket
9
of the solar cell
5
to a vertical wall using the
enclosed screws
7
(4 x 30 mm) and the enclosed wall plugs
8
(ø 6 mm) (see Fig. C).
Note: The enclosed mounting material is suitable for ordinary masonry
construction. Other wall substrates may require other fastening materi-
als. Seek specialist advice when in doubt.
After mounting, verify the solar cell
5
is fitted securely by the bracket
9
.
Then attach the solar cell as shown in Fig. C.
Next adjust the solar cell to face south.
Connecting the solar cell to the main unit
After mounting the two operating units (main unit
1
and solar cell
5
) run
the connection cable so it is not subjected to mechanical stress. Use typical
installation material such as cable clamps or conduit to fasten the connec-
tion cable, to prevent damage to the insulation.
Connect the plug connector
4
from the main unit connection cable
and the solar cell (see Fig. D).
Start-up
Note:
Connect the main station
1
to the solar cell
5
before using for the
first time. The solar cell
5
also works as a twilight sensor, while the
motion detector
3
only responds to movement.