8 GB/IE/NI
Danger to life by
electric shock
Always check lamp for damage
before connecting it to power.
Never use the light if it shows
any signs of damage.
Prior to installation, verify that
the mains voltage on site corre-
sponds with the operating
voltage required for the light
(230 V∼ 50 Hz). Otherwise do
not install the light.
CAUTION! DANGER OF
BURN INJURIES!
To prevent
burns, verify the light is switched
off and has cooled down for
at least 15 min before touching
it. Lamps can become very hot.
0.5 m
FIRE HAZARD!
Fit the light so that it
is at least 0.5 m
away from the material to be
illuminated. Excessive heat can
result in a fire.
CAUTION! RISK
OF INJURY!
Bro-
ken lamp glass must
be replaced before any further
use is made of the lamp.
Only intended for installations
out of normal reach.
This product does not contain
any parts that can be serviced
by the user. The LEDs cannot
be replaced.
The illuminant is not replaceable.
If the illuminant fails at the end
of its life, the entire light must
be replaced.
The spotlight is only suited for
use with the built-in LED control
gear.
The product continues to draw
a small amount of power even
if the lamp is off as long as
product is connected to supply
mains. To switch the device off
completely, the mains switch
should be switched off.
Before installation
Important:
The electrical con-
nection must be established by a
qualified electrician or a person
trained to perform electrical instal-
lations. This person must be familiar
with the properties of the light and
the connection regulations.
Содержание 279890
Страница 3: ...A B 5 6 7 2 4 10 9 8 3 1 ...
Страница 4: ...2 5 m C D 11 ...
