LIVARNO LUX 279106, Инструкции по эксплуатации и безопасности

Страница: 6 / 36

7 GB/IE/NI
Introduction / Safety Introduction
3
Socket
4
Mains cable with ON / OFF foot switch
5
Lamp base
6
Cap nut with washer
7
Spanner
8
Illuminant
Technical Data
Item number: 54508 / 54509
Operating voltage: 220–240 V∼ 50 / 60 Hz
Illuminant:
LED, E27, 12 W
Rated power max.: 60 W
Protection class:
II /
Dimensions: Height max. approx. 140 cm,
Ø approx. 46 cm
Distributor:
Edi Light GmbH, Heiligkreuz 22, A-6136 Pill,
www.edi-light.com
Safety
Safety Notices
Damage due to failure to comply with these operating
instructions will invalidate the warranty! We assume
no liability for consequential damage! We assume
no liability for property damage or personal injury
due to improper handling or failure to observe the
safety notices!
RISK OF AC-
CIDENT AND DANGER TO
LIFE FOR INFANTS AND CHIL-
DREN! This device may be used by children
aged 8 years and up, as well as by persons with
reduced physical, sensory or mental capacities,
or those lacking experience and / or knowledge,
as long as they are supervised or instructed in
the safe use of the device and they understand
the associated risks. Do not allow children to
play with the device. Cleaning and user
maintenance must not be performed by children
without supervision.
Do not leave the light or packaging material ly-
ing unattended. Plastic film or bags, plastic parts,
etc. can turn into dangerous toys for children.
Avoid the risk of fatal injury
from electric shock
We assume no liability for property damage
or personal injury due to improper handling or
failure to observe the safety notices!
Never use the light if any defects have been
identified.
Always check the lamp and the mains cable with
the plug for any damage before connecting it
to the mains.
Ensure that the light does not come into contact
with water or other liquids under any circum-
stances.
Never open any of the components of the elec-
trical equipment or insert any objects into the
same components. This will pose a risk of fatal
injury from electric shock.
Touch only the insulated part of the plug when
connecting to or disconnecting from the mains
supply!
To prevent hazards, if the external flexible lead
on this lamp is damaged it must be replaced
by the manufacturer, its service representative
or an equally qualified professional!
Before use, verify the available mains voltage
matches the voltage required for operating the
light (220–240 V~, 50 / 60 Hz).
Preventing fire and
injury hazards
CAUTION! RISK OF BURNS
DUE TO HOT SURFACES!
Ensure
the light has been switched off and
has cooled down before touching it to avoid
burns. Lamps become very hot.
Check each bulb for damage immediately after
unpacking.