LIVARNO LUX 271694, Инструкция по сборке, эксплуатации и безопасности

Страница: 11 / 56

9 GB
The illuminant is not replace-
able.
If the illuminant fails at the end
of its life, the entire light must
be replaced.
Before installation
Important: The electrical con-
nection must be established by a
qualified electrician or a person
trained to perform electrical instal-
lations. This person must be famil-
iar with the properties of the light
and the connection regulations.
Before installation ensure that
the circuit, to which the light
will be connected, is not ener-
gised. To do so, remove the fuse
or switch off the circuit breaker
in the fuse box (0 position).
Use the voltage tester to verify
the de-energised status.
The included mounting material
(screws
3
and wall plugs
1
)
is suitable for ordinary solid con-
crete or masonry construction.
Check which mounting material
is suitable for your chosen
mounting surface. If necessary,
seek expert advice.
The included ground stake
10
is suitable for mounting in soil
(e.g. lawn or flower bed). The
soil must be soft enough to push
the ground stake in without
applying force (e.g. hammer
strike), but must be firm enough
at the same time to ensure the
lamp is securely fixed.
Installation
When selecting the mounting loca-
tion, pay attention to the following:
Make sure that the spotlight
4
illuminates the desired area.
You can move the spotlight
vertically.
Make sure the motion detector
9
covers the desired area.
The motion detector has a
maximum coverage range of
10 m, with a coverage angle
of about 180° (depending on
the mounting height – a height
of 1.80–2.50 m is ideal).
Make sure the motion detector
is not illuminated at night by