LIVARNO LUX 14136401L, Инструкции по эксплуатации и безопасности

Страница: 22 / 24

22 GB
Maintenance and cleaning / Disposal / Warranty and service Safety / Initial use / Changing the light bulb / Maintenance and cleaning
This light is not suitable for dimmer
or electronic switches.
Bulb - Only insert in a dry
environment.
Safe working
Position the lamp so it is protected from moisture
and dirt.
Always be attentive! Always pay attention to
what you are doing and use common sense.
Do not cover the lamp with objects. Excessive
heat can result in fire.
Do not look into the illuminant from a close
distance during operation.
Do not use optical instruments to look at the
light source (e.g. magnifying glass).
In order to disconnect the light completely from
the power supply, the mains plug must be
removed from the socket.
Only use the LED light bulbs specified in the
chapter “Technical data“.
Initial use
Assembling the light
Note: Please remove all packaging material from
the product before assembly.
Use a clean, lint-free, dry cloth to insert the
light bulb
1
.
Screw the light bulb
1
clockwise into the lamp
socket
4
.
Take a slat
3
and carefully insert it with the
curve pointing downwards and outwards into
the lower ring
5
.
Then fit the upper ring
2
into the slat
3
.
You can now insert another slat
3
on the op-
posite side. Ensure that the spacing between the
slats
3
is correct (see Fig. B).
Note: Be careful not to damage the light
bulb
1
.
Assemble another two slats
3
each at approx.
90 ° on the upper ring
2
and lower ring
5
.
Now insert all the other slats
3
into the rings
2
,
5
.
Plug the mains plug
8
into a properly installed
socket.
Your light is now ready to use.
Switching the light on / off
Switch the light on and off by pressing the
ON / OFF switch
7
.
Changing the light bulb
Switch the light off using the ON / OFF switch
7
.
DANGER OF ELECTRIC
SHOCK!
Unplug the mains plug
8
from the socket.
CAUTION! RISK OF BURNS DUE TO
HOT SURFACES!
Allow the light to cool down completely.
Carefully remove 3-4 slats
3
.
Use a clean, lint-free, dry cloth when replacing
the light bulb
1
.
Unscrew the defective light bulb
1
from the
lamp socket
4
, turning counter-clockwise.
Only use the light bulbs specified in chapter
“Technical data“.
Screw a new light bulb clockwise into the lamp
socket
4
.
Carefully assemble the removed slats
3
.
Plug the mains plug
8
into a properly installed
socket.
Your light is now ready to use.
Maintenance and cleaning
Switch the light off using the ON / OFF switch
7
.