Little Wonder Xtra, Руководство владельца оператора

Страница: 26 / 32

Fit pinion bearing locating screw (43) and leave
nut loose (A). Using a screwdriver, lever
pinion firmly back to bearing locating screw
and tighten nut
(Fig. 19B).
NOTE: If this is not done, pinion or crown gear
could be tight. Correct distance is 6mm (.236”)
(Fig. 19A).
Refit and tighten screws (C) and self-tapping
screw (B)
(Fig. 19B).
NOTE: If new clutch housing fitted, use a 4mm
(.158”) drill and drill through B (Fig. 19B) so
self-tapping screw will screw in and locate new
clutch drum housing (only one screw necessary).
21. Replace crown gear if teeth are worn.
See sequence of assembly (Fig. 20).
22. Check and renew ‘O’ ring if necessary. Fit
assembly into housing. If bearing is loose in
housing, smear loctite around bearing before
assembling. Carefully drive down (making sure
gears are meshing) by gently tapping around
bearing area
(Fig. 21).
23. Fill or top up with gear lubricant. See Page 14
last paragraph “ LUBICATION OF GEARS”.
26
WARNING
Only use Little Wonder hardened
bevel washers (P/N 100506).
Soft washers will not allow blade to
tighten up and blade will slip in use.
Note washer assembly.
▲
!
▲
!
“O” RING