5
4
1. Attach the Lower Mattress Rails to the Lower Bunk Ends.
You need:
8x Bolts (100mm), 8x Barrel Nuts, an Allen key (and possibly a Screwdriver).
Attach the Lower Mattress Rails to the larger Lower Bunk (Head) Ends by inserting 8x Bolts
(100mm) through the holes in the Ends and into the holes in the ends of the Mattress Rails.
Insert the 8x Barrel Nuts into the holes on the inside faces of the Rails.
Be certain that you
have selected the correct Rails as the Lower and Upper Rails are similar but different.
Secure the Rails to the Ends by correctly engaging and tightening the Bolts into the Barrel
Nuts (shown in more detail below
A
). Ensure the mattress support rail is positioned closer to
the bottom of the Rail as shown below (
B
).
Note:
A screwdriver can be used to help align the
Barrel Nuts correctly.
Assembly
A
B
Mattress support rail
X
X
2. Attach the Upper Mattress Rails to the Upper Bunk Ends.
You need:
8x Bolts (100mm), 8x Barrel Nuts, an Allen key (and possibly a Screwdriver).
Note: At this stage you must decide at which End you require the Ladder. Please see the
orientation options page at the front of this instruction to help you decide.
This instructions shows the ladder positioned on the Right (orientation option A)
Attach the Upper Mattress Rails to the smaller Upper Bunk Ends Using the same assembly method as
step 1. As before, ensure the mattress support rail is positioned closer to the bottom of the Rail.
Also Note:
the 2x inserts in the top edge of each Rail (
X
).
Note: Do Not fully tighten the bolts until the entire bed is constructed. This will make it easier to
fit the guard rails.
5
3. Attach the Mattress Rail Stile.
You need:
2x Bolts (35mm) and an Allen Key.
Fit the Mattress Rail Stile to the Upper Mattress Rail using 2x Bolts (35mm). If the Ladder is
required on the right, the Mattress Rail Stile must be attached using the right hand pair of
holes on the appropriate Mattress Rail as shown below (Option A). If the Ladder is required on
the left (Option B), use the left hand pair of holes on the opposite rail.
4. Attach the Front Guard.
You need:
2x Bolts (80mm) and an Allen Key.
Attach the Front Guard to the Upper Front Mattress Rail by inserting 2x Bolts (80mm) through
the holes in the lower cross rail of the guard and into the holes in the top edge of the mattress
rail as shown.
Option A
Option B
Continued on the next page
