6
ENG
3. At such disorders as deep vascular sclerosis, weak pulse wave and also in
patients with the prominent distortions of cardiac rhythm it may be dif
fi
cult to
measure the blood pressure accurately. IN SUCH CASES CONSULT A CERTIFIED
DOCTOR ABOUT APPLICATION OF THE ELECTRONIC DEVICE.
4. KEEP QUIET DURING A MEASUREMENT TO OBTAIN THE ACCURATE
VALUES OF YOUR BLOOD PRESSURE WITH THE ELECTRONIC DEVICE.
Measure your blood pressure in the calm and comfortable conditions at the
indoor temperature. No eating an hour before measurement; no smoking, tak-
ing tonic agents, alcohol 1.5-2 hours before measurement.
5. The accuracy of blood pressure measurement depends on whether the cuff
matches the size of your arm. THE CUFF SHOULD NOT BE TOO SMALL OR
TOO LARGE.
6. Wait 3 minutes between measurements for the blood to restore
its circulation. However, the persons with prominent atheroscle-
rosis due to considerable loss of vascular elasticity may need to
increase the wait time between measurements (10-15 minutes).
This also refers to the patients suffering for long from diabetes.
For more accurate determination of blood pressure it is recommended to make
a series of 3 consecutive measurements and to use the average value.
POWER SUPPLY OF THE Device
BATTERY INSTALLATION
1. Open the cover of the battery compartment and
install 4 “AA” size batteries according to polarity
marked inside the compartment. Do not use much
force to remove the cover of the battery compart-
ment (Fig. 2).
2. Close the battery cover.
• Replace all batteries when the Low Battery
Indicator “
”, appears on the screen or
when there is no any indication on the screen.
The Low Battery Indicator does not show the
discharge level.
• The batteries supplied with the Device are
intended for check of the Device performance at
sale and their service life may be shorter than of
the recommended batteries.
• Replace all four batteries at the same time. Do not use the waste batteries.
• If the Device is unused for a long time, remove all batteries.
• Do not leave the waste batteries in the Device.
• Rechargeable power cells, type AA, may also be used
Fig. 2
