DELIVERY: Upon receipt of fi xture and accessories (packed separately), thoroughly inspect for
any freight damage. All damage should be reported to the delivery carrier. Compare the catalog
description listed on the packing slip with the fi xture label on the inside of the housing to be sure
you have received the correct merchandise.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Tools Required: 9/16" socket wrench. 3/16" allen wrench.
Figure 1
1. Attach mounting block to the pole by placing the fl at bar stock with the 3 holes, two of which
are threaded, inside the pole, aligning with the drill pattern (shown on next page). Place the cast
aluminum block on the outside of the pole, with the word “Up” towards the top of the pole and
facing outward or away from the pole. Thread the (2) 3/8" diameter hex head bolts through the
block and pole into the threaded bar stock. (There is no gasket needed). Check plumb and level
of the block and secure bolts tightly with 9/16" wrench or socket. (See Figure 1)
2. Insert the wires from the fi xture through the center hole of the mounting block assembly,
pulling them into the pole. Place the luminaire over the mounting block while tilted up at a slight
angle above horizontal, and then tip back down to horizontal once oriented on the block making
certain the wires are not pinched. For ease of installation, the mounting block will hold the weight
of the luminaire prior to tightening the mounting bolt. (See Figure 2)
3. To secure the fi xture, open doorframe by loosening the (2) captive screws using 3/16" allen
wrench. (See Figure 3)
4. Tighten the locking hex head bolt inside the arm with a 9/16" socket to 20-30 ft. lbs. torque
(overtightening will cause stripping and void all warranties). (See Figure 4)
5. Check the mounted assembly to assure proper placement and secured mounting has been
achieved such that the fi xture is fully seated on the cleat and arm is fl ush with pole.
6. Close the doorframe and tighten the (2) captive doorframe screws.
7. Make wire connections, observing proper voltage and polarity. Connect green ground wire
from the fi xture to the fi eld ground wire. Reference wiring diagram on driver. Secure wires; push
back into pole.
Troubleshooting: If this fi xture fails to operate properly, check to make sure: • The fi xture is wired correctly. • The fi xture is
grounded correctly. • The line voltage at the fi xture is correct. If all these variables have been checked and the fi xture still
does not operate as specifi ed, contact your local Lithonia Lighting distributor.
Part Number: RJ521357 Rev A
Revision Date: 3-5-13
Installation Instructions
DSX0 LED
5 year limited warranty
Lithonia Lighting Outdoor • One Lithonia Way • Conyers, Georgia 30012
Phone: 800-279-8041 • Fax: 770.918.1209 •
www.lithonia.com
© 2011 Acuity Brands Lighting, Inc. All rights reserved.
Figure 2
Figure 3
Figure 4
UP
Mounting block has has this reinforced cast
step and the word "UP" cast into it once.
This mounting block ships in the fi xture carton.