2016 | Lithionics Battery LLC | SOCV6 REV0
PRE-RELEASE
4
Initial Installation:
Upon unpacking please inspect all components for obvious damage due to shipping.
The SoC Sending Box has BATTERY
+
, LOAD
+
, and a SoC NEGATIVE REFERENCE WIRE which must be
connected correctly for accurate SoC calculation. Please refer to the chart and instructions below.
1.
Begin by turning off ALL LOAD devices both charging and discharging. Turn the battery off, or
if it is equipped with an external NeverDie unit, turn it off as well.
2.
Connect the SoC NEGATIVE REFERENCE WIRE to the battery negative (-) terminal.
3.
Connect the battery positive
+
to the BATTERY
+
on the SoC Sender Box.
NOTE: If you have an external NeverDie unit on your battery system the Load + of the
NeverDie must be connected to the B on the SoC Sender Box.
4.
Connect the LOAD + to your charge and discharge loads (ideally a common bus bar).
5.
Connect any accessories you may have ordered with your SoC Meter system.
6.
Power the battery or NeverDie unit back on.
7.
To calibrate the SoC Meter to the batteries actual SOC%, please allow 1 charge cycle to
complete fully.
8.
Installation complete.
