page 8
12. Testing Your Fan.
motor housing
reverse
switch
diagram 1
diagram 2
diagram 3
11. Remote Control Operation.
If you wish to use the wall bracket from hardware pack,
install bracket screws from hardware pack through
bracket and into the desired installation site. The
remote control transmitter rests inside the bracket.
It is recommended that you test fan before finalizing
installation. Test fan speeds with the different fan speed
buttons on the remote control transmitter. Test the light
ON/OFF function with the button on the remote control.
Test dimmer function by holding down the button for up
to 0.7 seconds.
If the remote control operates all of the functions of the fan
and light, battery has been installed correctly. If fan and/or
light do (does) not function, please refer to "Troubleshooting"
section to solve any issues before contacting Customer
Service.
Turn fan completely off
before
moving the reverse switch
(located on top of motor housing.) Set reverse switch to
recirculate air depending on the season:
- LEFT position in summer (
diagram 1
)
- RIGHT position in winter (
diagram 2
A ceiling fan will allow you to raise your thermostat setting in
summer and lower your thermostat setting in winter without
feeling a difference in your comfort.
Important
: Reverse switch must be set either
completely to
the LEFT
or
completely to the RIGHT
for fan to function. If the
reverse switch is set in the
middle
position (
diagram 3
), fan
will not operate.
3
button
for fan HIGH speed
2
button
for fan MEDIUM speed
1
button
for fan LOW speed
0
button
to turn fan OFF
button
to turn light ON or OFF
Tap button quickly to turn lights off or on. Hold
button down to increase or decrease lights. If you
press button in excess of 0.7 seconds, it becomes a
dimmer. The lights vary cyclically in 0.8 seconds. The
light button has an auto resume function, which keeps
the light at the same brightness as the last time it was
turned off.
WallBracket
Wall
Bracket
Screws
