page 7
9. Light Kit Assembly.
Remove glass shade from light kit fitter.
Remove 1 screw from post located on underside of
fitter plate and partially loosen the other 2 screws.
Connect
WHITE
wire from motor housing to
WHITE
wire from light kit fitter. Connect
BLACK
(or
BLUE
) wire
from motor housing to
BLACK
wire from light kit fitter.
Be sure molex connections snap together securely.
Align slotted holes in light kit fitter with loosened
screws in fitter plate. Twist light kit fitter to lock.
Re-insert screw that was previously removed and
tighten all 3 screws securely.
Install 2 medium base 6.5-watt LED bulbs (included).
Important
: When replacing bulbs, please allow bulb(s)
and glass shade to cool down before touching them.
Align grooves on glass shade previously removed with
nodules on inside of light kit fitter and push up gently
on glass shade. Twist glass shade to the RIGHT
(clockwise) until glass shade locks into place.
Pull down
VERY GENTLY on glass shade to make sure that glass
shade is secure.
CAUTION
:
The remote control transmitter can be programmed
to multiple receivers or fans. If this is not desired, turn wall
switch off to any other programmable receiver or fan.
10. Automated Learning Process./Activating Code.
(back
side)
Battery
Cover
Remote
Control
Transmitter
9V
Battery
Remove battery cover from back of remote control
transmitter. Install 9-volt battery (included) with
positive (+) end toward top of remote control
transmitter.
Replace battery cover on remote control transmitter.
WARNING
:
Choking Hazard
- Small parts. Keep battery
away from children.
IMPORTANT
: To prevent damage to remote control
transmitter, remove the battery if not used for long
periods. Store the transmitter away from excess heat or
humidity.
CAUTION
: “DO NOT DISPOSE OF BATTERIES IN FIRE,
BATTERIES MAY EXPLODE OR LEAK.” - When disposing
of household alkaline batteries, it is best to check with
your local and state recycling or household hazardous
waste coordinators concerning the specifics of the
program in your area. You may also locate a recycling
center by calling 1-800-8-BATTERY or 1-877-2-RECYCLE
or visit www.epa.gov/epawaste/index.htm or
www.earth911.org for more information.
Restore electrical power. Within 30 seconds of
restoring electrical power, press and hold the “0”
button on the remote control transmitter for 5 seconds
or until light on the fan blinks twice. Test the fan and
light functions to confirm the learning process is
complete--see Section 12.
motor housing
light kit fitter
glass shade
bulb
motor housing
molex connections
light kit fitter
fitter plate
Modifications not approved by the party responsible for compliance
could void the user's authority to operate the equipment.
*NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
