5. Fan Assembly. (cont.)
page 5
6. Wiring.
ground (green
or bare)
white supply wire
black supply wire
white
black
white
blue
blue
black
from receiver
black
AC IN L
AC IN N
white
whit
e
ground (green
or bare)
from fan
from receiver
antenna
from ceiling
receiver
black
*
(wiring for receiver)
WARNING
: Turn off circuit breakers to
current fixture from breaker panel and be
sure switch is turned to the OFF position.
CAUTION
:
Be sure outlet box is properly
grounded and that a ground wire (
GREEN
or
Bare) is present.
Make sure all electrical connections comply
with Local Codes or Ordinances and the
National Electrical Code. If you are unfamiliar
with electrical wiring or if the house/building
wires are different colors than those referred to
in the diagram to the right, please use a
qualified electrician.
DANGER:
If using this fan in a DAMP location,
this fan must be connected to a supply
circuit that is protected by a Ground Fault
Circuit Interrupter (GFCI) to reduce the risk of
personal injury, electrical shock or death.
Wire the RECEIVER
with wire connectors
provided
as shown in diagram at right.
Tip
: While you are wiring, keep in mind that
wires must not obstruct receiver from sliding
into hanging bracket.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
Insert receiver (flat side up) into hanging
bracket and carefully push taped wire
connectors into outlet box. Allow antenna
from remote control receiver to hang
outside
of hanging bracket.
With the hanging bracket secured to the outlet box and
able to support the fan, you are now ready to hang your
fan. Grab the fan firmly with two hands. Slide downrod
through opening in hanging bracket and let hanging ball
rest on the hanging bracket. Turn the hanging ball slot
until it lines up with the hanging bracket tab.
WARNING
: Failure to align slot in hanging ball with tab in
hanging bracket may result in serious injury or death.
Tip:
Seek the help of another person to hold the
stepladder in place and to help lift the fan up to you
once you are set on the ladder.
Modifications not approved by the party responsible for compliance
could void the user's authority to operate the equipment.
*NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
hanging ball slot
motor housing
hanging bracket tab
