page 6
7. Wiring.
WARNING
: Turn off circuit breakers to current fixture
from breaker panel and be sure switch is turned to the
OFF position.
CAUTION
:
Be sure outlet box is properly grounded and that
a ground (
GREEN
or Bare) wire is present.
Make sure all electrical connections comply with Local
Codes or Ordinances and the National Electrical Code. If you
are unfamiliar with electrical wiring or if the house/building
wires are different colors than those referred to in the
instructions, please use a qualified electrician.
Note
:
Excess lead wire length from the fan can be cut to the
desired length and then stripped.
When downrod is secured in place on the hanging
bracket, electrical wiring can be made
as follows:
Connect
BLACK
and
BLUE
wire from fan to
BLACK
wire
from ceiling with wire connector provided.
Connect
WHITE
wire from fan to
WHITE
wire from
ceiling with wire connector provided.
Connect all
GROUND
(
GREEN
) wires together from fan
to
BARE
/
GREEN
wire from ceiling with wire connector
provided.
If you intend to control the fan light with a separate light
switch, connect
BLUE
wire from fan to the
BLACK
(or
RED
) supply from the independent switch.
* Wrap each wire connector separately with electrical
tape as an extra safety measure.
black
black
white
white
black supply wire
white supply wire
from
ceiling
from fan
ground
(green or bare)
ground
(green
or bare)
8. Canopy Assembly.
hanging bracket
canopy
Temporarily raise canopy to hanging bracket to
determine which 2 screws in hanging bracket align
with
slotted
holes in canopy, and then lower canopy
and
partially loosen
these 2 screws.
Remove
the
other
2 screws/lock washers and set aside.
Now, lift canopy to hanging bracket again, aligning
slotted holes in the canopy with loosened screws in
hanging bracket. Twist canopy to lock. Re-insert the
other 2 screws/washers and secure all screws with a
Phillips screwdriver.
wire
connector
blue
This fan is remote control adaptable (remote
control sold separately).
Note
: Only remote
controls approved for DAMP locations can be
used with this fan.
