motor housing
reverse switch
10. Testing Your Fan.
diagram 1
diagram 2
diagram 3
diagram 4
page 8
It is recommended that you test fan before
finalizing installation. Restore power from
circuit box and light switch (if applicable). Test
fan speeds with the pull chain labeled FAN.
Start at the OFF position (no blade
movement). First pull will set the fan to HI.
Second pull will set the fan to MEDIUM. Third
pull will set the fan to LOW. Fourth pull will
again set the fan to the OFF setting. Test light
with the pull chain labeled LIGHT. (
diagram 1
)
If fan and/or light do (does) not function,
please refer to "Troubleshooting" section to
solve any issues before contacting Customer
Service.
Turn fan completely off
before
moving the
reverse switch (located on the switch
housing). Set reverse switch to recirculate air
depending on the season:
- LEFT position in summer (
diagram 2
)
- RIGHT position in winter (
diagram 3
)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower your
thermostat setting in winter without feeling a
difference in your comfort.
IMPORTANT
: Reverse switch must be set
either
completely LEFT
or
completely RIGHT
for
fan to function. If the reverse switch is set in
the
middle
position (
diagram 4
), fan will not
operate.
Attach pull chain extensions supplied or
custom pull chain extensions (sold separately)
to ends of the pull chains.
fan
pull chain
extension
light
pull chain
extension
switch
housing
