page 6
7. Canopy Assembly.
Locate 2 screws on underside of hanging
bracket and remove screw closest to the
open end of the hanging bracket. Partially
loosen the other screw. Lift canopy to
hanging bracket. Place rounded part of
slotted hole in canopy over loosened screw
in hanging bracket and push up. Twist
canopy to lock. Re-insert screw that was
removed and then tighten both screws
securely.
Slide canopy cover up to canopy, rotating
canopy cover until the small nodules on the
opening of the canopy cover (
refer to
drawing at right
) align with small gaps on
the underside of the canopy. Push up on
canopy cover and then turn canopy cover
approximately
90°
.
8. Blade Assembly.
WARNING
: To reduce the risk of serious
bodily injury, DO NOT use power tools to
assemble the blades. If screws are
overtightened, blades may crack and break.
Time Saver
: Washers for blade screws can
be set on each blade screw prior to
installing blades.
Locate 18 blade attachment screws and
washers in hardware pack. Hold blade arm up
to blade and align holes. Insert 3 blade
attachment screws (along with washers) with
fingers first and then tighten screws securely
with a Phillips screwdriver. Repeat for the
remaining blades.
Remove all blade arm screws/lock washers
from underside of motor. Align blade arm
holes with motor screw holes and attach
blade arm with blade arm screws/lock
washers. Before securing screws permanently,
repeat with remaining blade arms. Securely
tighten all screws.
NOTE
: Tighten blade arm screws twice a year.
blade arm
blade
blade arm screws/
lock washers
motor
housing
blade attachment
screws and washers
hanging
bracket
canopy
canopy cover
90°
nodule
gap
