9. Light Kit Assembly (Optional). (cont).
page 8
10. Testing Your Fan.
It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light switch (if
applicable). Test fan speeds with the pull chain on switch
housing. Start at the OFF position (no blade movement). First
pull will set the fan to HI. Second pull will set the fan to
MEDIUM. Third pull will set the fan to LOW. Fourth pull will
re-set the fan to OFF setting. If applicable, test light with pull
chain in the middle. If fan and/or light do (does) not function,
please refer to "Troubleshooting" section to solve any issues
before contacting Customer Service.
Turn fan completely off
before
moving the reverse switch. Set
reverse switch to recirculate air depending on the season:
- LEFT position in summer (
diagram 1
)
- RIGHT position in winter (
diagram 2
)
A ceiling fan will allow you to raise your thermostat setting in
summer and lower your thermostat setting in winter without
feeling a difference in your comfort.
Important
: Reverse switch must be set either
completely to the
LEFT
or
completely to the RIGHT
for fan to function. If the
reverse switch is set in the
middle
position (
diagram 3
), fan will
not operate.
Pull chain extensions supplied or custom pull chain extensions
(sold separately) may be attached to the ends of the pull
chains.
switch housing
center plug
hex nut
lock
washer
light kit fitter
BLACK
WHITE
WHITE
BLUE
If you wish to use the fan WITHOUT the light kit
, locate
wires in switch housing (at top of light kit fitter) labeled FOR
LIGHT. Gently pull molex connections apart in order to
disconnect these wires.
Next, remove the hex nut and lock washer from the threaded
rod at the top of the light kit fitter. Unscrew the switch
housing to remove it from the light kit fitter and then gently
feed the
BLACK
and
WHITE
wires from the light kit fitter
through the hole in the middle of the switch housing.
Locate plastic cap in one of the hardware packs and place
firmly in hole in middle of switch housing. Connect female
plug from switch housing to male plug from motor housing.
Be sure that plugs connect completely.
Align slotted holes in switch housing with loosened screws in
switch housing plate. Twist switch housing to lock and
securely tighten all 3 screws with Phillips screwdriver.
diagram 1
diagram 2
diagram 3
