NOTE
: The important safety precautions and
instructions appearing in the manual are not meant to
cover all possible conditions and situations that may
occur. It must be understood that common sense and
caution are necessary factors in the installation and
operation of this fan.
page 4
5. Fan Assembly.
yoke set screw
downrod
yoke cover
electrical wiring
clip
pin
set screw hole
set screw
hanging ball
stop pin
A
B
If you wish to extend the hanging length of your
fan, you must remove the hanging ball from the
downrod provided to use with an extended
downrod (sold separately). [
If you wish to use the
downrod provided, please proceed to instructions
following the dotted line below.
]
To remove hanging ball, loosen set screw on
hanging ball, lower hanging ball and remove stop
pin. Slide hanging ball off the original downrod, A,
and slide it down the longer downrod, B (the top
of the downrod should be noted as having a set
screw hole; use this hole when setting the set
screw). Insert stop pin into top of extended
downrod and raise hanging ball. Be sure stop pin
aligns with slots on the inside of the hanging ball.
Tighten set screw securely.
Tip
: To prepare for threading electrical wires
through downrod, apply small piece of electrical
tape to the ends of the electrical wires -- this will
keep the wires together when threading them
through the downrod.
Loosen yoke set screws and nuts on motor
housing yoke and remove pin and clip from motor
housing yoke. Slide downrod through canopy and
yoke cover.
Thread electrical wires through downrod and pull
extra wire slack from the upper end of the
downrod.
Place downrod into the motor housing yoke and
re-insert pin and clip that were previously
removed. Tighten yoke set screws and nuts
securely. Lower yoke cover and canopy to motor
housing.
["Fan Assembly" continued on next page.]
canopy
motor
housing
