Liteville 601 Mk3, Руководство пользователя, Страница: 14 / 24

14
Syntace X-12 thru-axle
The Syntace X12 through axle system is the only through axle system that allows adjustment of track and
camber. The Allen key bolt on the right hand drop out is purely for attachment of the derailleur hanger and to
clamp the thread insert. It does not require removal when removing the rear wheel!
Note: The axle insert has been adjusted to your specific
frame. This can be seen by the alignment of mark and
clamping slit when 0.5mm and 0.1mm eccentrical inserts
are used.
Setup
Adjusting shock preload
For optimal performance we highly recommend spending some good time to set the suspension up correctly.
Proceed as follows:
• Push the O-ring on the shock body right back against the shock seal.
• Now, place one foot on the first step of some stairs and carefully get on the bike with your full riding outfit
(including helmet, riding shoes, full backpack etc.) without any unnecessary weight shifting or “bouncing”.
• Carefully get off the bike without any further compression of the shock and check where the O-ring is.
• Measure the the distance between O-ring and shock seal.
• Depending on riding style, shock used
and personal preference, the O-ring
should be 20-40% of thew stroke away
from the shock seal (see diagram).
• If the distance is greater, add some air
into the shock.
• If the distance is less, release some air
from the shock.
Caution: even a backpack or hydration backpack will change the applied load on the suspension setup to the
extend that it will require re-adjusting of the shock’s air pressure.