Listen AmpConnect621, Руководство пользователя

Страница: 19 / 67

AmpConnect 621
™
Manual Hardware and Calibration 13
AmpConnect 621 Hardware Configuration
The Vp values for the AmpConnect 621 are factory-programmed, and are automatically loaded into the
Hardware Editor when “
Automatically create Signal Paths for Listen Devices ” is turned on. See Plug
and Play on page 9 .
The Calibration Editor is also updated with the correct signal paths for the associated hardware. See
SoundCheck Calibration Configuration on page 15 .
If AmpConnect 621 is added to an existing SoundCheck configuration, the channels will automatically be
displayed in the hardware editor after the pre-existing channels.
Important! Do not use different input and output driver types for an audio interface,
e.g.: ASIO for inputs and WASAPI for outputs. Doing so will result in an
Acquisition Step error.
WDM Drivers
WDM drivers are available in the Hardware Editor for AmpConnect 621. WDM drivers only allow access to
Input Channels 1 and 2 of AmpConnect 621.
Note: WDM drivers do not allow for consistent Latency and require that you use Auto Delay or Auto
Delay+ in any Analysis Step. WDM drivers should not be used when making Absolute Phase
measurements.
Figure 4-10: Hardware Editor Vp Values