Lissmac DTS 271, Руководство по эксплуатации

Страница: 14 / 22

14
3.5 Check sense of rotation of the saw blade
• Shortly turn star-delta switch (Pos. 12) to "star"
• Verify sense of rotation of saw blade.
* Sense of rotation seen from left side in clockwise direction (indication arrow on the blade
guard).
3.6 Change of sense of rotation
• Turn off mains switch (Pos. 6).
• Remove supply cable from plug (Pos. 5).
• Turn phases of plug (Pos. 5) using a screw driver.
* Press white disk inwards and turn it.
3.7 Trial run
During the operation the position of the operator is in front of the handles (Pos. 13).
Danger! Avoid any contact with the running saw blade. Wear tight clothes.
• Place a brick on the masonry saw.
• Position brick to limit stop.
• Position switch (Pos. 12) to “star”.
• Wait till motor has achieved a constant r.p.m. (constant noise).
• Turn switch (Pos. 12) to position "triangle".
ATTENTION! Is there enough cooling water for the saw blade?
• Dry cuts prohibited.
• An insufficient quantity of cooling water results in premature wear or defect of the
saw blade.
• Start advance movement via handle (Pos. 13).
* First cut at low advance speed.
* Adjust advance speed to advance force.
4. Transport
4.1 Transport preparations
• Disconnect saw from the supply cable.
• Remove water from the tub.
• Height adjustment (Pos. 7) is fixed.
• Lock the sawing table.
4.2 Dislocation via building crane
• Hang up the four suspension gear with sufficient carrying force into the eyelets provided for this
purpose at the limit points (Pos. 14).
• Always watch saw when dislocating.
4.3 Transport on a lorry
Fasten saw at the limit stop (Pos. 14) by means of tension belts.
Caution!