Introduction
The DigidownCR device downloads data from tachograph cards into its internal
memory. After these data files have been downloaded then they can be uploaded
via Bluetooth to wherever they are required. This is performed via a Digidown
Base box direct to the relevant place or via a suitable Bluetooth-enabled mobile
phone to anywhere in the world.
Initial Set Up
When using the Bluetooth upload function in conjunction with a mobile phone
then the correct destination e-mail address must be recorded in the internal
memory. The file DigidownBlueDataDestination.exe is required to perform this
operation. This file can be found in the UPDATES folder on the DigidownCR drive
(when DigidownCR is connected to a PC via USB cable) or, for the latest version,
download it from www.lisledesign.com/DigidownCR/.
In order to send data via Bluetooth, a pair of AAA-size batteries is required
(supplied with the unit). Please observe the correct polarity when inserting the
batteries.
Modes of Operation
The DigidownCR can operate in ‘USB mode’ or in ‘Battery mode’.
USB Mode:
The DigidownCR is defined as being in USB mode when it is connected to a PC or
similar device via a USB cable. In this mode (whilst no smartcard is inserted) the
device acts as a mass storage device with all the capabilities of such a device.
DigidownCR can download tachograph card files whilst in USB mode, but it does
not attempt to upload these files via Bluetooth.
Battery Mode:
DigidownCR is in Battery mode whenever it is not connected via USB. In this
mode DigidownCR remains powered off until such time as a tachograph card is
inserted.
In this mode (and upon completion of a card download), DigidownCR initiates the
Bluetooth upload sequence to transfer all card files (not previously uploaded) to
the user specified location.
